How an Old Chair Became French

Step 1. Find your chair

   This chair needed the legs tightened, some new fabric and a lighter color paint or stain.

Step 2. Pop off the chair seat and pick a fabric that you like. I chose a patterned blue and white fabric to give a French country flare.

Step 3. Place the fabric on the floor and the seat faced down so that the underneath part is facing toward the ceiling.

Step 4. Take a staple gun ****carefully**** and staple the fabric to the back of the chair seat. You want it to be tight enough to hold its form but lose enough so that you don’t rip it when you sit.  Cut any excess fabric from the edges and check your seat to make sure it has no lose corners.

If you find one side is pulling more than the other you can simply tighten the other side and stapling again. The process is very forgiving so give yourself a little credit.

Drink some wine too that helps me.

 The seat is right side up here in step 4 the seat should be side down.

Step 5. Sand any varnish off your chair frame using a hand sander or a sand block. If there isn’t a shiny varnish you can get away with lightly sanding instead of going down to the grain.

Let it fully dry and apply a second coat of paint. I used behr paint and primer for this one but you can use any paint you want, chalk paint is very popular because it goes on even and you don’t need too much of it.

Step 6. This is optional, you can distress the edges if you like that look by gently sanding along the corner of the chair legs and making a few strokes along the middle, not too symmetrically though because you want it to look naturally vintage and not forced.

Step 7 is place your set on top of the completed frame and you can either glue it in or screw it in depending on the chair itself, if the chair has drilled holes for screws, utilize them if not, glue will do.

Ta da buds and gals you did it, you made an ugly old chair beautiful again!


Now celebrate by sitting in your new chair proudly!

Advertisements